Date: 2016-05-20

Prepared by: MA/RS

Title: CHIME LNA Post-Assembly instructions 

1. Manually solder two SMA connectors (Part Number: 002900)
 on the PCB, J1 and J2 location.

2. Install the spacer nuts on the SMA connectors (no lock washers), running them off the threaded
section of the SMA body so that this nut turns freely.

3. Label the Enclosure. See LNA_RevC_Label.JPG.
(labels are provided: Part Number 002715).

4. Place the PCB in the bottom enclosure section, centering the PCB between sides of the enclosure
and insert the provided assembly spacer beneath the PCB so that the PCB is held snug against the
solder tabs of the enclosure. 

5. Place a lockwasher and SMA nut on the connector; tighten the nut with 5 in-lbs torque.

6. Solder tabs.

7. Run test #1.

8 Close the box and install outer SMA nut; tighten the nut with 5 in-lbs torque.

9 Solder shut.

10 Run test #2.

(test time in each case is under a minute including connection and placement).
